Yes - makes perfect sense. I just walked through all of this now, looks good!
The reason I asked is because there is an option to send the Aux1 or Aux2 Output and it comes programmed as "muted" then you can disengage that to show 50% for level and then a dry, post and pre....so should I engage the send to 50% and dry? I assume muted, is exactly as it sounds and nothing would come out.
All set up and ready to rock, @ST! Thanks again for your help - you're the best!
The last question, I am not upgraded to the newest software on the T4S. I don't have the cable to perform the update; not sure if I will prior to Saturday. IS there a huge difference/disadvantage to being on 1.01? Thanks again for your incredible help!
You may have the required cable kicking around someplace. It's the kind of cable you use to connect a printer to a PC. If you don't have one, most stores that sell printers can sell you one.
Here's how you do the update.
It may look complicated but you can follow the video step-by-step and pause it if you need to, along the way.
We're up to firmware version 1.0.6. You can read the T4S/T8S Version history.
There have been several changes since version 1.0.1, including corrections to the routing of Aux 1 and Aux 2, routing of USB B from PC, and improvements to the way reverb is handled on the Aux 1 output.
It's only Wednesday. Please do the firmware update before the gig.
I was messing with the sends from the T4s....does Aux 5/6 not make it to the Aux out? I sent the T1 signal to Aux 5. Then the aux out 1 or 2 wasn’t getting a signal. But then I sent the T1 signal to Ch4 in T4s and the aux 1 and 2 were getting a signal. Is it a thing that aux in doesn’t make aux out? It’s ok if so, I can route T1 into a main channel. But maybe I’m missing something @ST?
Yep, sounds good. After some fiddling, I will end up sending the T1 to CH4 in my T4s. Turns out I am using the system a bit different:
T1: Fiddle player, guitar and 1vox -->Ch4 T4s (wet send, flat receive in T4s)
T4s: 1Vox, guitar (Ch4 having the wet T1)
T4s: Digital power from wall, Aux 1 Send to Compact for monitor, main out RIGHT (all panned) to house system XLR and they control loudness as I'll send a relatively hot signal.
This worked in my dry run last night; sound about right for this application use?