cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Joe Nardi
Contributor
  • 1
  • 244
  • 0
Registered since

Mar 31, 2010

I think I stumbled across the line level indicator on accident.

So I noticed I had my line 1 volume all the way down and I was turning up the volume on my mixer which was hooked up to line one.  What I noticed was eventually line 1 started showing me a red flickering even though I didn't have the volume on line 1 up at all.  So my question is....is this red flickering indicator actually showing me the line-level going into the speaker since I'm showing a clipping indicator when I don't even have the volume up.

1 REPLY 1
Dylan_R
Moderator

Re: I think I stumbled across the line level indicator on accident.

Hey Joe,

The signal indicator LED reacts to the incoming signal only, and is not affected by the channel volume level. If the incoming signal is too hot, the signal indicator LED will still show red regardless of the channel volume level.

We recommend setting the trim level on your system so that the LED is showing green, indicating a healthy signal without clipping. 

Hope this helps!

Feel more. Do more. Be more.
Come check out my profile here. New to the community? Check out the Getting Started board.
Help others find answers to your questions by clicking on 'Accept as Solution' at the bottom of a reply. If you see a post you like, make sure to give it a thumbs up!