Highlighted
Audible Advocate
  • 0
  • 2
  • 0
Registered since

Nov 28, 2019

L1 Model II DJ Setup

I just got the Bose L1 Model II with the B2 Bass, I have the Pioneer XDJ-RX2 Controller and I was wondering what is the best way to get this Monster working properly without using the Bose T1 ToneMatch.

Thank you for your help guys.

3 REPLIES 3
Highlighted
Vocal Volunteer
  • 63
  • 227
  • 1
Registered since

Mar 29, 2010

Re: L1 Model II DJ Setup

No doubt @ST will  have the right (and detailed answer), but to hazard a guess ... a TRS cable from your Pioneer Master out to the L1 analog In jack ought to do the job.

Highlighted
Professional Legend
  • 1407
  • 48121
  • 1
Registered since

May 11, 2020

Re: L1 Model II DJ Setup

Hi, Deibys.

Welcome.

Deibys posted:

I just got the Bose L1 Model II with the B2 Bass, I have the Pioneer XDJ-RX2 Controller and I was wondering what is the best way to get this Monster working properly without using the Bose T1 ToneMatch.

Thank you for your help guys.

The L1 Model II Power Stand is a mono device and L1 Model II Power Stand Analog input is a balanced, mono connection. Please do NOT connect a stereo source here. It won't work.

You need to get a mono output from the Pioneer XDJ-RX2 Controller.

It looks like you can use the right output from either Master1 or Booth connections.

If you use the Master1 output use an XLR to 1/4 inch (6.3 mm) Tip-Ring-Sleeve cable.

If you use the Booth output use a  1/4 inch (6.3 mm) Tip-Ring-Sleeve to 1/4 inch (6.3 mm) Tip-Ring-Sleeve cable.

Then set the monitor output to MONO, SPLIT.

Reference: Pioneer Quick Start page 16

Does that help?

ST 

Highlighted
Audible Advocate
  • 0
  • 2
  • 0
Registered since

Nov 28, 2019

Re: L1 Model II DJ Setup

Thank you guys for this information, I will buy the XLR to 1/4 inch (6.3 mm) Tip-Ring-Sleeve cable.

Thank you @troubador for the recommendation, and also thank you @ST for you help.

I appreciate it.

Best,