Hi again. So I have two B2's on each side of my system. One uses a Packlite amp on each side. I run in stereo, using the T1 ethercon connection to drive one side and the Aux side to power the other. I get a balance between the two sides and then use VirtualDJ to control the overall volume.
I have found that the side connected with the Ethercon connection is always very sensitive to clipping. I am often seeing the red clip light come on, even though the volume, while loud, does not seem excessive to me.
Any ideas why this might be? It seems the aux side doesn't suffer from that problem. I don't have the packlite amps marked so I am not sure which physical amp is on each side each time. I may have to do that to determine if it's one particular amp but I don't think so since the aux side of the system never seems to have the problem no matter how much I crank the system.
Thoughts? Advice? Thanks ............ Rob