Highlighted
Collaborator
  • 18
  • 69
  • 0
Registered since

May 18, 2017

T1 mic stand mount

Back in 2010 I bought one and broke it on the first use-- the plastic nub that the clamp grabbed on to.  I thought I later read that Bose strengthened them.  So I bought one a couple weeks ago.  Six uses in, the pin broke (like a watch strap pin).  Was fitted  perfectly to my mic stand -, too.  Just barely snug... Should I try again.  A phenomenally terrible design

5 REPLIES 5
Highlighted
Professional Legend
  • 1412
  • 48121
  • 1
Registered since

May 11, 2020

Re: T1 mic stand mount

Hi Tom,

I'm sorry that microphone stand adapter broke. Please call Bose Support on Monday and see if they can help.

Call Bose® Product & Technical Support at (877) 335-2673
(U.S. and Canada only)
Monday-Friday: 9:00 AM - 9:00 PM ET

As an aside, I leave my microphone stand adapter attached to the microphone stand. I don't attach and remove them at every gig.  Mine have been fine like this for years.

ST

Highlighted
Member
  • 2
  • 3
  • 0
Registered since

Sep 17, 2017

Re: T1 mic stand mount

Thanks for your input Tom, I just purchased a T1 mic stand bracket from the Guitar Center and the tech assured me the plastic bracket would hold the T1. I looked at the Sweetwater T1 mic stand bracket comments and many experienced musicians are commenting on the "poor design". I'll hold my comments until I start using it at gigs.

My L1 Model 2 has been in my studio for years and the bracket that attaches to the L1 speaker has not been an issue, as the studio is a controlled environment.  However I've always felt there should have been a thumb screw attaching the bracket to the bottom of the T1, to have a positive attachment method. The mic stand bracket would also be more secure with this method (if modified on new T1 units).

 

 

Highlighted
Professional Legend
  • 1412
  • 48121
  • 1
Registered since

May 11, 2020

Re: T1 mic stand mount

Hi David,

Thank you for joining the Community.

I have all my cables strapped to the microphone stand so that T1® is secure.

Click the picture to read a more detailed article about using the T1® Microphone Stand bracket.

ST

Highlighted
Member
  • 2
  • 3
  • 0
Registered since

Sep 17, 2017

Re: T1 mic stand mount

Wow, the Bose community is 'on the ball.' Thank you Tom! I feel much better about how to properly install the bracket, T1 and cables to the mic stand. I also sent a note to both the Guitar Center and Sweetwater asking them to make a link to these installation instructions. Thank you. 

PS, I guess I don't have to tell anyone here how stellar my Bose L1 Model 2 system sounds.

Dave Arpin 

Highlighted
Participant
  • 1
  • 7
  • 0
Registered since

Aug 26, 2017

Re: T1 mic stand mount

How do  ? - ? - ? - ? - ? - ? - ? - ? -  ... Please see the new discussion we created for you question. Click the grey area below. Thank you.