cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
motionblu
Participant
  • 1
  • 9
  • 0
Registered since

Apr 9, 2019

T8S No sound from Aux 1 output

I have a microphone on channel 1 going to Aux 1 output, but getting no sound from the speaker. I am getting a signal to Aux, so not sure whats happening?

Can you also explain how I would route the music coming from the PC (7&8) to Aux 1?

3 REPLIES 3
ST - Pro
Professional Legend
  • 1430
  • 48121
  • 3
Registered since

May 11, 2020

Re: T8S No sound from Aux 1 output

Hi D,

Please make sure the firmware on the T8S is up to date.

T4S/T8S Firmware Update Instructions



There were some routing issues that were resolved through a firmware update.

Then, please check out this article.

T8S Aux Outputs

[local image not available]

Please click the picture for more details.

  ST

monikajaymes
Participant
  • 0
  • 1
  • 0
Registered since

Jun 3, 2021

Im having the same problem. Just bought the t8, updated t...

Im having the same problem. Just bought the t8, updated to 1.1.4, getting output signals in all aux's but no sound. I have tried an in ear monitor and a powered floor monitor. Also, i plugged headphones in and i have no volume control? 

thanks for your help in advance- monika

Fish-54
Mentor
  • 84
  • 319
  • 57
Registered since

Aug 1, 2010

Re: Im having the same problem. Just bought the t8, updated t...

Hello monikajaymes,

 

Sorry you're having a problem with your T8s.

 

While the 1.1.4 update should have taken care of this, I have to ask:  Did you perform the required "Factory Reset" after completing the firmware upgrade?  If so, you may need to contact Bose Support directly.

 

If you didn't do the Factory Reset, then the firmware may not have "activated".  (NOTE:  If you have any saved scenes, back them up before performing the Factory Reset.  You can restore them afterwards.  Also, this procedure only applies to the T8s and T4s, not the T1.)  First, turn off the T8s. Then press and hold the MUTE buttons for Channels 1, 2, 3, and 4 simultaneously while you turn on the power. The T8s should show "Rebooting", "Factory Reset Please Wait", then "Factory Reset Complete".  (You can release the buttons when you see "Please Wait".)

 

Does that help?