• 3
  • 122
  • 0
Registered since

Oct 8, 2008

AmpLink Amps in Project View

Can the AmpLink versions of the PowerShare and IZA amps be added to the devices in the project view with the ability to wire a connection between the AmpLink output of a processor to the amp? I realize that this is purely graphical, but it is nice to be able to clearly show the signal flow. Along with this, it would be much appreciated if AmpLink on amps could be shown with an In  and a Through to again show the actual connection scheme rather than showing them in a star configuration.


Moderator - Retired
  • 12
  • 1310
  • 18
Registered since

Oct 27, 2017

Re: AmpLink Amps in Project View

Hi Eric,

As you said, it is only graphical but nice to have.

I will log these 2 requests.