cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Bruce Morriss
Participant
  • 0
  • 1
  • 0
Registered since

Jul 6, 2020

CC-1D/CC-2D/CC-3D

Hello all, 

 

Is there an accepted method for selectively enabling/disabling the volume and source selection on CC-1D/CC-2D/CC-3D controls, ideally using one of the digital GP inputs? 

 

CC-1D/CC-2D/CC-3D with EX series processor

 

USA

 

Firmware Version

 

App Version

 

What devices were you using that were affected and what version are they on (e.g. Samsung Galaxy S9 on Android 11, iPhone X on iOS14, etc.)

Detailed description of the issue and steps to reproduce

 

What environment do you experience the issue in? (e.g. noisy office, quiet kitchen, etc.)

 

When did you start to experience the issue? Did it work correctly previously?

 

Any troubleshooting steps you took

 

 

2 REPLIES 2
Mear1628
Contributor
  • 2
  • 22
  • 0
Registered since

May 20, 2020

Re: CC-1D/CC-2D/CC-3D

I haven't tested it, but perhaps you can add the CCxD to Psets (with and/or without Volume / Source selection) and invoke the Pset using the GPI?

ChrisJ-at-Bose
Moderator

Re: CC-1D/CC-2D/CC-3D

Hi Bruce,

 

This would be difficult to accomplish, because there is no way of remapping the CC-xD controllers. However, you could:

  1. Create a split audio path using a router (before the gain block the controller is using), keep one signal going through the gain block, and the other bypassing it.

  2. Use a mixer after this block to combine both signals down to one.

  3. Save a parameter set with the router sending the signal through the gain block, and another with the router sending the signal to the unaffected straight path.

  4. Use these parameter sets as an on/off trigger in your GPI panel.

 

Best Regards,

 

ChrisJ-at-Bose