cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
paulsven
Contributor
  • 1
  • 2
  • 0
Registered since

Aug 28, 2020

MSA12x doesn't remember input source and gain with power is interrupted.

I am using analog in for the system I've installed.  If for any reason the AC power to the array is disrupted when the power comes back on it won't remember the input source, and defaults to Dante. It also doesn't remember the gain setting.  All of this means the system is down until a computer is connected and the input / gain reset.

 

Any ideas?  Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
arno-at-bose
Moderator - Retired
  • 12
  • 1309
  • 20
Registered since

Oct 27, 2017

Re: MSA12x doesn't remember input source and gain with power is interrupted.

Author Accepted Answer selected by paulsven

Hello Paulsven,

 

If no preset is stored, the MSA12X will boot with the default settings.
Have you tried to store your new settings (Analog input / gain)?
Default Power On State is Preset 1 (which you also can change if needed)

Before you can store your new preset you might need to change the beam setting (just change it 0.1 degrees and change it back)

BR
Arno

View solution in original post

2 REPLIES 2
arno-at-bose
Moderator - Retired
  • 12
  • 1309
  • 20
Registered since

Oct 27, 2017

Re: MSA12x doesn't remember input source and gain with power is interrupted.

Author Accepted Answer selected by paulsven

Hello Paulsven,

 

If no preset is stored, the MSA12X will boot with the default settings.
Have you tried to store your new settings (Analog input / gain)?
Default Power On State is Preset 1 (which you also can change if needed)

Before you can store your new preset you might need to change the beam setting (just change it 0.1 degrees and change it back)

BR
Arno

View solution in original post

paulsven
Contributor
  • 1
  • 2
  • 0
Registered since

Aug 28, 2020

Re: MSA12x doesn't remember input source and gain with power is interrupted.

Thanks Arno - that solved the problem.

 

Paul