Highlighted
Participant
  • 0
  • 2
  • 0
Registered since

Aug 28, 2020

PB ControlSpace Designer v5.8.2

I changed the IP address of my ESP-88 to 192.168.1.160 in the "Hardware Manager" menu. But now I cannot change the IP address of my ESP because the "Hardware Manager" cannot find my ESP.

While in the "Project view" if I scan my ESP is found. 😫

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Bose Employee
  • 80
  • 1258
  • 7
Registered since

Oct 27, 2017

Re: PB ControlSpace Designer v5.8.2

Author Accepted Answer selected by totodup

Hello totodup,

 

Is it possible for you to check the network settings via the RS232 port?

Query IP address:
IP<CR>
Query subnet mask:
NP M<CR>
Query gateway:
NP G<CR>

Restore network settings to default (192.168.0.160)
NP F<CR>

Please see also page 14-15 of the serial protocol (CSD 5.8) 

BR
Arno

View solution in original post

1 REPLY 1
Highlighted
Bose Employee
  • 80
  • 1258
  • 7
Registered since

Oct 27, 2017

Re: PB ControlSpace Designer v5.8.2

Author Accepted Answer selected by totodup

Hello totodup,

 

Is it possible for you to check the network settings via the RS232 port?

Query IP address:
IP<CR>
Query subnet mask:
NP M<CR>
Query gateway:
NP G<CR>

Restore network settings to default (192.168.0.160)
NP F<CR>

Please see also page 14-15 of the serial protocol (CSD 5.8) 

BR
Arno

View solution in original post