Highlighted
Contributor
  • 3
  • 91
  • 0
Registered since

Jan 9, 2018

PM8500 front panel configuration

hi 

if i configured the PM8500 via front panel, settings will be saved automatically on the amplifier??

peace 

4 REPLIES 4
Highlighted
Bose Employee
  • 89
  • 1310
  • 17
Registered since

Oct 27, 2017

Re: PM8500 front panel configuration

Hi Abboud,

 This depends on the Power Up State under the PM properties.

When Restore Last Settings is selected, the amplifier will save its current operating state when powering down, or entering standby. When power is restored these settings will be restored. This is the default operation for USB-only models.

When Restore Last Settings is deselected, the initial 'power on state' that was saved at the time the configuration was sent to the hardware using ControlSpace Designer software will be used when power is restored. This is the default operation for network models.

BR
Arno

 

 

Highlighted
Contributor
  • 3
  • 91
  • 0
Registered since

Jan 9, 2018

Re: PM8500 front panel configuration

so if i want to save the settings(routing, Speaker EQ, Delay....) without using CSD. what i have to do ??

Highlighted
Bose Employee
  • 89
  • 1310
  • 17
Registered since

Oct 27, 2017

Re: PM8500 front panel configuration

Hi Abboud,

The USB version should store these settings by default.
For the network version you need to change this setting using CSD - USB or network (can't be done via the front panel).

Easiest way to check is to go to the menu using the front panel and if you do not see a warning message on the display, the settings should be stored.

Br
Arno

 

Highlighted
Contributor
  • 3
  • 91
  • 0
Registered since

Jan 9, 2018

Re: PM8500 front panel configuration

clear. thank you