Highlighted
Participant
  • 1
  • 46
  • 0
Registered since

May 28, 2018

Parameter set causing Red Power LED

Hi. User has created a new file in CSD5.7 including many parameter sets. This is causing a Red power LED on upload to ESP1240AD, with no audio passing. When P-Sets are eliminated the system operates as expected. Is this a known issue and is there a work around we can apple? Attached are the CSD files: One that caused the failure and one that works

5 REPLIES 5
Highlighted
Bose Employee
  • 78
  • 1230
  • 4
Registered since

Oct 27, 2017

Re: Parameter set causing Red Power LED

Hi Steve,

sorry you run into this issue and this issue has been logged.

This issue occurs when you add a CC-64 to a Pset on an ESP FIXED IO.
The advise for now is to not update in these cases and use CSD 5.6.2 till we resolve this issue.

BR
Arno

Highlighted
Contributor
  • 1
  • 17
  • 0
Registered since

Aug 30, 2018

Re: Parameter set causing Red Power LED

Happened to me too. ESP-1240 (silver) upgraded, power LED lit yellow for boot (did it before?), after boot it turned red. 

Funny thing tho; after update, the ESP bootlooped in 30ish second intervals ?? Bootloop was resolved by replugging AC. Rolling back to 5.6.2 FW now, hope the XML isn't mangled ??

Highlighted
Contributor
  • 1
  • 17
  • 0
Registered since

Aug 30, 2018

Re: Parameter set causing Red Power LED

Still borked, can't go online with it either. Red power LED, error message from CSD 5.6.2 reads "Fail in connecting to device" port 10001 ERROR=[0040]

Highlighted
Contributor
  • 1
  • 17
  • 0
Registered since

Aug 30, 2018

Re: Parameter set causing Red Power LED

Resolved by 

System > Retrieve Saved Design

And going online by send to device.

Highlighted
Bose Employee
  • 78
  • 1230
  • 4
Registered since

Oct 27, 2017

Re: Parameter set causing Red Power LED

HI Peter,

With CSD 5.7 we introduce an automatic recovery, so you can at least connect to the ESP again when the netlist is corrupted.

Using Retrieve Saved Design you can retrieve the loaded design file and work from there.

We are working on resolving the CC-64 / Pset.

BR
Arno