cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Lars_Justesen
Contributor
  • 0
  • 133
  • 0
Registered since

May 20, 2010

Resizing conical surfacegroups

When resizing conical surfacegroups, built with radius #2 set to zero, Modeler will make that divided into chunks of surfaces and lines - sometimes with a following crash, sometimes not.

2 REPLIES 2
Lars_Justesen
Contributor
  • 0
  • 133
  • 0
Registered since

May 20, 2010

Re: Resizing conical surfacegroups

Using Modeler 6.10.17 btw

Thomas_S
Bose Employee
  • 25
  • 669
  • 1
Registered since

May 20, 2020

Re: Resizing conical surfacegroups

Hi Lars,

thanks for the notification.

In general, I'd advise to not use the conical tool with an inner radius set to Zero. This will create duplicate vertices for each surface and those are actually not allowed and are likely the cause for a crash.

Of course, Modeler shall prevent that dup vertices are created, so we'll pass this on to Engineering.

Best rgds,

Thomas