setchy
Audible Advocate
  • 0
  • 3
  • 1
Registered since

Nov 23, 2015

Bose Cinemate 130 and PS4 HDMI-CEC Control

Hi all,
Sometime in the last week, my Bose Cinemate 130 has stopped being able to control my PS4 via HDMI (HDMI-CEC / Link).
I use to be able to press the 'Game' input, which would wake-up/power-on the PS4 and then I could navigate around the XMB interface.
Now, it will only wake-up/power-on the PS4 but will not allow me to navigate.
I have tried plugging the PS4 directly into my Sony TV, which works perfectly.
Has anyone else experienced this?  I'm not sure if it is related to a SoundTouch update or a PS4 update
Thanks
Adam
1 ACCEPTED SOLUTION

Accepted Solutions
This widget could not be displayed.
setchy
Audible Advocate
  • 0
  • 3
  • 1
Registered since

Nov 23, 2015

Re: Bose Cinemate 130 and PS4 HDMI-CEC Control

Found my own answer, sharing for those who find themselves in a similar position.  Turns out I had somehow re-programmed the GAME input to use IR instead of CEC.
Found this in the manual and followed the steps with success
Reset a source button on the remote control
If you are experiencing problems with a source button on the remote control, reset
the source button to the factory settings.
After performing this procedure, your source button is in CEC mode.

  1.  On the remote control, press and hold the appropriate source button until all six source buttons glow, then release. Only the appropriate source button glows.
  2. On the number keypad, enter 0140.
1 REPLY 1
This widget could not be displayed.
setchy
Audible Advocate
  • 0
  • 3
  • 1
Registered since

Nov 23, 2015

Re: Bose Cinemate 130 and PS4 HDMI-CEC Control

Found my own answer, sharing for those who find themselves in a similar position.  Turns out I had somehow re-programmed the GAME input to use IR instead of CEC.
Found this in the manual and followed the steps with success
Reset a source button on the remote control
If you are experiencing problems with a source button on the remote control, reset
the source button to the factory settings.
After performing this procedure, your source button is in CEC mode.

  1.  On the remote control, press and hold the appropriate source button until all six source buttons glow, then release. Only the appropriate source button glows.
  2. On the number keypad, enter 0140.